Insights to run quality better.
Articles on QMS, compliance, audits, validation, and digital transformation for regulated industries.
139 articles in Audits & Inspections
Night-Shift Blind Spots When IATF Layered Audits Miss the Same Fixture Error Each Quarter
Night-Shift Blind Spots When IATF Layered Audits Miss the Same Fixture Error Each Quarter. Floor stop rules, roles, and inspection questions for IATF layered audit fixture.
Read more →
Conformal Coat UV Inspection That Misses the Connector Shadow the IPC Photo Never Showed
When UV inspection misses the connector shadow the IPC photo never showed
Read more →
Composite Repair Photos That Skip the Ply Orientation Shot the SRM Requires
When repair photos skip the ply orientation shot the SRM requires
Read more →
Paint Booth Gloss Readings Taken After the Panel Has Already Cooled Below the Spec Window
When gloss readings are taken after the panel cools below the spec window
Read more →
CCP Probe Placement That Reads the Jacket Not the Coldest Spot in the Kettle
When the CCP probe reads the jacket not the coldest spot
Read more →
Pouch Seal Peel Force That Passes Average and Fails the Weakest Corner
When average peel force passes and the weakest corner fails
Read more →
Internal Audit Aisle Hold When the Sample Plan Skips a Bay
A floor hold guide for qms teams when the record looks closed and the physical state is still open.
Read more →
Turbine Blade Holds: When Visual Passes Then FPI Shows a Linear Indication
When a turbine blade visual pass is followed by a linear FPI indication, hold the serial, freeze the NDT record, and reconstruct etch, dwell, and lighting before anyone returns the blade to stock.
Read more →
EM Plate Holds: When Settle Plates Recover After a Grade A Excursion
When Grade A settle plates recover after an excursion, hold the session, freeze EM maps, and reconstruct airflow, personnel, and incubation before anyone releases associated lots.
Read more →
Incoming CoA Holds: When Dimensions Pass Then the Heat Number Does Not Match the Packet
When incoming dimensions pass and the heat number on the part does not match the CoA packet, hold the receipt, freeze identity, and reconstruct mill certs before anyone issues to stock.
Read more →
Incoming CMM Holds: When First Article Passes and the Next Five Fail the Same Feature
One passing first article does not clear a lot. Hold remaining pieces when the next five fail the same feature.
Read more →
Engine Shop Torque Holds: When the Wrench Angle Does Not Match the Log
An angle that does not match the log is an incomplete fastener, not a paperwork fix. Hold the engine until the joint is identified.
Read more →