Insights to run quality better.
Articles on QMS, compliance, audits, validation, and digital transformation for regulated industries.
29 articles in Aviation & Aerospace
Second-Person Misses On FOD Findings Closed Without Source Inspection Follow-Through
Second-Person Misses On FOD Findings Closed Without Source Inspection Follow-Through. Floor stop rules, roles, and inspection questions for FOD source inspection.
Read more →
Effectiveness Gaps When AS9100 Work Order Revisions Do Not Match the Floor Traveler
Effectiveness Gaps When AS9100 Work Order Revisions Do Not Match the Floor Traveler. Floor stop rules, roles, and inspection questions for AS9100 traveler revision.
Read more →
Torque Wrenches That Leave the Crib After Cal Due and Still Get Stamped on the Job Card
When a torque wrench leaves the crib after cal due and still gets stamped
Read more →
Composite Repair Photos That Skip the Ply Orientation Shot the SRM Requires
When repair photos skip the ply orientation shot the SRM requires
Read more →
Composite Vacuum Bag Leak After a Shift Handoff
A floor hold guide for aviation teams when the record looks closed and the physical state is still open.
Read more →
CMM Datum Holds: When First Article Passes Then Shift Pieces Fail the Same Feature
When first-article CMM passes and later pieces fail the same datum, hold the lot, freeze the program and fixture, and reconstruct alignment and tool wear before anyone recuts.
Read more →
FOD Shadow-Board Holds: When a Bay Is Empty and the Tool Tag Is Still Open
An empty shadow-board bay with an open tag is a missing tool. Hold the aircraft zone until the tool is found or accounted.
Read more →
Incoming CMM Holds: When First Article Passes and the Next Five Fail the Same Feature
One passing first article does not clear a lot. Hold remaining pieces when the next five fail the same feature.
Read more →
Incoming Molded Housing Holds: When First Article Passes and Lot Flash Returns
When First Article Passes and Lot Flash Returns
Read more →
Composite Ply Orientation NCRs: Proving the Layup Photo Matches the Ply Book
A ply book without a timestamped layup photo is an NCR waiting for the next AS9100 walk.
Read more →
CMM Program Revisions Mid First Article: Who Owns the Alignment Change
A first-article report that used last week's CMM alignment is a document-control miss, even if the part is in spec.
Read more →
SMT Reflow Profile After a Solder Paste Change
Paste change without a new profile is a latent defect generator. First article X-ray and wetting have to close before volume starts.
Read more →